warmanw

When I rotate a bone with pose tool while it is partially constrained, the bone jumps for few degrees and after that follows the tool

https://drive.google.com/open?id=1txQk2bsSApr7LXlRaQefllm13Ov1tV6w&authuser=warmanw%40gmail.com&usp=drive_fs
Avatar
warmanw

Kickstarter Backer
  • Postovi: 332

Misaki

Thank you for your reporting. I tried to reproduce the behavior, but unfortunately I couldn't. That video does not show the parameters of the transformation constraint, so could you show us that?
Avatar
Misaki

Misaki
  • Postovi: 755

warmanw

Try this file?
Nemaš dopuštenje za pregledavanje privit(a)ka dodan(og)ih postu.
Avatar
warmanw

Kickstarter Backer
  • Postovi: 332

Misaki

Thank you for attaching the Spine project! However, I could not reproduce the problem on my PC even if I tried with the project. The behavior that I saw was like the video below.

To make it easier to see where the cursor is, I used a tool that displays a circle around the cursor, and you can see that the circle and the green target icon of the Pose tool are aligned.

I'm sorry I couldn’t find the cause, but this might be a problem that depends on the operating environment. We would appreciate it if you tell us about your current PC environment.

---

For your information, you mentioned in your other post that you set the interface scale to 150%, so I tried that setting as well, but could not reproduce this issue.
Avatar
Misaki

Misaki
  • Postovi: 755

warmanw

just posting another project with the bug, maybe this can b reproduced

video https://drive.google.com/open?id=1wHLuUU8E-buKV88AALoGHzPfwj6y7-qp&authuser=warmanw%40gmail.com&usp=drive_fs
Nemaš dopuštenje za pregledavanje privit(a)ka dodan(og)ih postu.
Avatar
warmanw

Kickstarter Backer
  • Postovi: 332

Misaki

Sorry for the delay in response. Even with the newly uploaded Spine project, I could not reproduce the behavior on my PC. Sorry to keep you waiting, but we would appreciate it if you could give us a few days to confirm.
Avatar
Misaki

Misaki
  • Postovi: 755

Søren

All the tools, not only the Pose tool work on the local transform, so what you're seeing is the final pose after constraints are applied. This can sometimes make it a bit troublesome to work with constraints where the Mix value is not 0 or 100, but it is not a bug.
Avatar
Søren

Shiu
  • Postovi: 2451

warmanw

thanks for checking it. for me only pose tool was snapping to different values. rotation tool works perfectly fine. but nevermind happy at least that you are aware of that workflow
Avatar
warmanw

Kickstarter Backer
  • Postovi: 332


Natrag na Bugs